[[email protected] ~]$ ifconfig -a
eth0      Link encap:Ethernet  HWaddr 00:1F:D0:83:10:76  
          inet addr:192.168.14.140  Bcast:192.168.14.255  Mask:255.255.255.0
          inet6 addr: fe80::21f:d0ff:fe83:1076/64 Scope:Link                
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1                
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0                
          TX packets:6 errors:0 dropped:0 overruns:0 carrier:0              
          collisions:0 txqueuelen:1000                                      
          RX bytes:0 (0.0 b)  TX bytes:468 (468.0 b)                        
          Interrupt:16 Base address:0x6000                                  
eth1      Link encap:Ethernet  HWaddr 00:1F:D0:80:6A:78  
          inet6 addr: fe80::21f:d0ff:fe80:6a78/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:1713 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1651 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000                           
          RX bytes:703482 (686.9 Kb)  TX bytes:306875 (299.6 Kb) 
          Interrupt:17 Base address:0x2000                       
lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:20 errors:0 dropped:0 overruns:0 frame:0
          TX packets:20 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:1000 (1000.0 b)  TX bytes:1000 (1000.0 b)
ppp0      Link encap:Point-to-Point Protocol
          inet addr:172.16.101.176  P-t-P:192.168.250.2  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1492  Metric:1
          RX packets:1305 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1405 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:3
          RX bytes:636957 (622.0 Kb)  TX bytes:260954 (254.8 Kb)

# /etc/rc.conf - Main Configuration for Arch Linux
# -----------------------------------------------------------------------
# LOCALIZATION
# -----------------------------------------------------------------------
#
# LOCALE: available languages can be listed with the 'locale -a' command
# HARDWARECLOCK: set to "UTC" or "localtime"
# USEDIRECTISA: use direct I/O requests instead of /dev/rtc for hwclock
# TIMEZONE: timezones are found in /usr/share/zoneinfo
# KEYMAP: keymaps are found in /usr/share/kbd/keymaps
# CONSOLEFONT: found in /usr/share/kbd/consolefonts (only needed for non-US)
# CONSOLEMAP: found in /usr/share/kbd/consoletrans
# USECOLOR: use ANSI color sequences in startup messages
#
LOCALE="ru_RU.utf8"
HARDWARECLOCK="localtime"
USEDIRECTISA="no"
TIMEZONE="Asia/Krasnoyarsk"
KEYMAP="ru-utf"
CONSOLEFONT="ter-p16n"
CONSOLEMAP="cp866_to_uni"
USECOLOR="yes"
# -----------------------------------------------------------------------
# HARDWARE
# -----------------------------------------------------------------------
#
# MOD_AUTOLOAD: Allow autoloading of modules at boot and when needed
# MOD_BLACKLIST: Prevent udev from loading these modules
# MODULES: Modules to load at boot-up. Prefix with a ! to blacklist.
#
# NOTE: Use of 'MOD_BLACKLIST' is deprecated. Please use ! in the MODULES array.
#
MOD_AUTOLOAD="yes"
#MOD_BLACKLIST=() #deprecated
MODULES=(mii r8169 snd-mixer-oss snd-pcm-oss snd-hwdep snd-page-alloc snd-pcm snd-timer snd snd-hda-intel soundcore)
# Scan for LVM volume groups at startup, required if you use LVM
USELVM="no"
# -----------------------------------------------------------------------
# NETWORKING
# -----------------------------------------------------------------------
#
# HOSTNAME: Hostname of machine. Should also be put in /etc/hosts
#
HOSTNAME="arch"
# Use 'ifconfig -a' or 'ls /sys/class/net/' to see all available interfaces.
#
# Interfaces to start at boot-up (in this order)
# Declare each interface then list in INTERFACES
#   - prefix an entry in INTERFACES with a ! to disable it
#   - no hyphens in your interface names - Bash doesn't like it
# 
# DHCP:     Set your interface to "dhcp" (eth0="dhcp")
# Wireless: See network profiles below
#
eth0="eth0 192.168.14.140 netmask 255.255.255.0 broadcast 192.168.14.255"
INTERFACES=(eth0)
# Routes to start at boot-up (in this order)
# Declare each route then list in ROUTES
#   - prefix an entry in ROUTES with a ! to disable it
#
gateway="default gw 192.168.14.250"
ROUTES=(!gateway)
 
# Enable these network profiles at boot-up.  These are only useful
# if you happen to need multiple network configurations (ie, laptop users)
#   - set to 'menu' to present a menu during boot-up (dialog package required)
#   - prefix an entry with a ! to disable it
#
# Network profiles are found in /etc/network.d
#
# This now requires the netcfg package
#
#NETWORKS=(main)
# -----------------------------------------------------------------------
# DAEMONS
# -----------------------------------------------------------------------
#
# Daemons to start at boot-up (in this order)
#   - prefix a daemon with a ! to disable it
#   - prefix a daemon with a @ to start it up in the background
#
DAEMONS=(syslog-ng network sensors alsa hal netfs crond kdm adsl)